Voltage Supply - WIKA CPH62I0 Betriebsanleitung

4. Design and function
The sockets for the connection of the interface can also be used for the function of
analogue output. For this, a corresponding analogue connection cable must be used.
The "interface" or "analogue output" operating mode must be configured via
menu and affects battery life!
Model CPH62I0-S1
2
1 Interface connector or optional analogue output
2 Connection channel 1 (only with CPH62I0-S1)
3 Connection channel 2 (only with CPH62I0-S2)
4 Connection channel 1 (only with CPH62I0-S2)

4.4 Voltage supply

DANGER!
Danger to life due to loss of explosion protection
Non-observance of these instructions and their contents may result in the
loss of explosion protection.
▶
Only use the listed batteries, see chapter 3.6.3 "Permitted batteries"!
▶
Only replace the batteries outside the hazardous area, see chapter
8.2 "Battery replacement"!
The voltage supply of the instrument is made via a 9 V battery. This is included in the
scope of delivery.
The battery life is approx. 300 hours of continuous operation with one sensor and a
measuring rate of 4/s.
WIKA operating instructions, model CPH62I0
1
Model CPH62I0-S2
4 3 1
EN
17