Storing Set Points; Recalling Set Points; Automatic Step Function; Manual Step Function - WIKA CEP 3000 Betriebsanleitung

6. Commissioning, operation

6.3 Storing set points

In the set point mode, up to 9 values can be stored for each area in the permanent
memory.
Procedure:
a. Set the output signal to the desired value.
b. Press the SHIFT and then the SET key.
c. Define the desired location with the keys 1 to 9 (confirm with ENTER).
d. Enter a new value and repeat steps 1 to 3 if needed, until 9 set points are stored at
most for each function.

6.4 Recalling set points

a. In order to recall set points, press the SHIFT key and then the SPT key.
b. Enter the number of the location where the desired set point was stored earlier.
c. The instrument sets the corresponding output signal.

6.5 Automatic step function

In a special function, the model CEP3000 can auto-step through all stored set points by
means of the step function.
Procedure:
a. Press the SHIFT key and then the AUTO key.
b. The message "Auto SPT ?" is displayed. Enter the last location. Example: If all 9
set points are stored, but only the first three values shall be recalled, enter "3" in this
query.
c. In the next window, a dwell of 5 to 500 seconds can be entered. Enter the desired
dwell here (confirm with ENTER).
d. The automatic step function is started.
e. For stopping the automatic step function, press the CE key or enter a value.

6.6 Manual step function

On the model CEP3000, all or some of the stored set points can be selected manually.
Procedure:
a. Press the SHIFT key and then the MAN key.
b. Go through the stored set points upwards and downwards by using the arrow keys.
c. To quit, press CE or enter a new initial value.
WIKA operating instructions, model CEP3000
GB
21