Power-Off Function; Instrument Output (Ovt); Analogue Output Scaling With Dac.0 And Dac.1 (Dac.) - WIKA CPH62I0 Betriebsanleitung

6. Commissioning, operation
6.4.7 Power-off function (P.oFF)
If no button is pressed and no serial communication occurs during the switch-off delay,
the instrument will automatically switch itself off. The switch-off delay can be set between
1 and 120 min. If "P.oFF" = "oFF" then the power-off function is deactivated.

6.4.8 Instrument output (Ovt)

DANGER!
Danger to life due to loss of explosion protection
Non-observance of these instructions and their contents may result in the
loss of explosion protection. Through working in flammable atmospheres,
there is a risk of explosion which can cause death.
▶
Operation of the serial or analogue interface is not permitted in hazardous
areas!
The output can be used as a USB or RS-232 interface or as an analogue output (0 ... 1 V).

6.4.9 Analogue output scaling with dAC.0 and dAC.1 (dAC.)

DANGER
Danger to life due to loss of explosion protection
Non-observance of these instructions and their contents may result in the
loss of explosion protection. Through working in flammable atmospheres,
there is a risk of explosion which can cause death.
▶
The use of the analogue output is not permitted in hazardous areas!
WARNING!
Damage to property through incorrect measuring instruments
By using incorrect measuring instruments, this damage could occur to the
hand-held.
▶
Only connect passive voltmeters to the analogue output.
Analogue output cannot be used during logger recordings.
With dAC.0 and dAC.1 the analogue output can be easily scaled.
▶
It must be ensured that the analogue output is not loaded too heavily, otherwise the
output value can be corrupted and the power consumption of the instrument increases
correspondingly.
WIKA operating instructions, model CPH62I0
EN
29