Access Code Functions - ECOLAB CDI01 Bedienungsanleitung

8.3

Access code functions

Within the menu ACCESS CODE FUNCTIONS it is possible to activate, deactivate and
change the access code.
Perform the activation of the access code as follows:
1. Activate the menu ACCESS CODE FUNCTIONS.
2. Activate the menu ACTIVATE ACCESS CODE.
3. Press ↵ and enter the desired four digit code in the menu INPUT CODE
4. Press NEXT to confirm the code.
Perform the deactivation of the access code as follows:
1. Activate the menu DEACTIVATE ACCESS CODE.
2. Press ↵ and enter the actual access code within the menu INPUT CODE.
3. Press NEXT to confirm the deactivation of the code.
Perform the change of the access code as follows:
1. Activate CHANGE ACCESS CODE ?
2. Press ↵ and enter the old code within the menu INPUT OLD CODE.
3. Press NEXT and enter the new code within the menu INPUT NEW CODE.
4. Press NEXT to confirm the new code.
The access code can be activated, deactivated or altered using a mastercode 2351,
knowledge of the access code that has been set, is not required.
NOTE
If the NEXT key is used to confirm
the old code is reset and an active code is deactivated. (Factory setting) A new code can
be selected freely again.
417101089_CDI01.doc
four times
0000 in the menu CHANGE ACCESS CODE,
- 49 - Rev.: 4-01/10