Initial Operation; A) Removing The Car Body; B) Installing The Receiver's Antenna Cable - Reely ROAD Hotlander Bedienungsanleitung



8. Initial operation

a) Removing the car body

The car body is secured with 4 holding brackets (1 and 2)
which have to be slid out of the retaining pins. Afterwards
the body (3) can be lifted off towards the top.

b) Installing the receiver's antenna cable

The receiver's antenna cable is normally rolled up on
delivery.
Unwrap the antenna cable completely and smoothen it
carefully.
Now insert the antenna cable (1) from below through the
attachment (see illustration on the right).
Guide it through the antenna tube and plug the antenna
tube into the attachment.
If a rubber cap is enclosed for the antenna tube, it prevents
the dislocation of the cable after attachment on the tip.
Make sure that the antenna cable does not protrude into the drive or touches the cardan shaft! It is
normally sufficient to slightly tighten the cable or fix it in place with a cable binder.
Figure 1
Figure 2
29