E) Installation Of Electronic Cruise Control; F) Installation Of Receiver - Reely ROAD Sports Car Bedienungsanleitung

e) Installation of electronic cruise control

A cruise control for 540 standard motors is totally sufficient for the built-in electric motor. However, should you want to
upgrade later to a more powerful racing motor, it is recommended to buy a cruise control right from the beginning that
is laid out for this purpose.
The electronic cruise control (1) is fastened with servo tape
to the chassis bottom instead of the cruise control servo.
In order to connect the motor with the cruise control, please
use the respective motor connecting cable (2), eg, Conrad
item no. 22 40 37, that can be soldered directly to the con-
tacts of the motor connection.
The possibly existing cruise control switch (3) is fastened
with servo tape or double-sided adhesive tape to the steer-
ing servo frame.

f) Installation of receiver

The receiver (1) is fastened with servo tape to the vertical
chassis plate (see also illustration 8, pos. 4).
Afterwards the antenna wire of the receiver is pushed from
the bottom through the wire holder (2).
Once the cruise control and the steering servo have been
connected to the receiver, you can fold the cables and se-
cure them with a small cable fastener (3).
Now slide the antenna wire of the receiver through the an-
tenna tube (1) and insert it in the therefore designated holder
on the chassis link.
Afterwards fasten the coupling nut (2). Make sure that the
antenna wire does not drag on the cardan shaft (3).
4
1
3
2
1
3
1
2
3
2
Figure 8
Figure 9
Figure 10
35