Performing A Test - HemoSense INRatio2 PT Benutzerhandbuch

EN
13. Set the higher limit of the target range
1
The higher limit of the target range will be flashing, and the
High Target symbol (
message will also appear on your test result display whenever
your result falls above the higher limit. Use the and
buttons to change the higher limit.
Press the
the display.
After setting the higher limit, "OK?" will begin flashing on the
display. If the target range is correct, press the
store the target range in the monitor. You will return to the
monitor display that prompts you to insert a test strip.
Or, if you would like to re-enter a target range, press the and
buttons to go back to the lower limit and repeat steps 12 and 13
until the correct target range is on the monitor display.
Example monitor displays when test results fall outside the target range
The Low Target symbol (
on the display whenever your result falls below the lower limit
of your target range.
(Example test result below
target range — INR mode)
The High Target symbol (
on the display whenever your result is above the upper limit of
your target range.
(Example test result above
target range — INR mode)
) will appear on the display. The "HI"
button when you have the correct higher limit on
button to
) will appear with your test result
) will appear with your test result
NOTES:
• If you need to go back and correct any selections before you exit, you will need to repeat
all Setup steps. Press the Setup button
are prompted to insert a test strip. Press the Setup button
mode where you will begin by setting the date.
• After you complete all Setup steps, you will return to the monitor display where you first
entered Setup mode.
• Your date, time, display mode, and target range settings are stored in the monitor using
battery power. If you are using a Power Supply and have removed the batteries (or the
batteries have completely run down), you will lose your settings within about two hours if
you unplug the Power Supply. To save your settings, install or replace the batteries as
needed even when using a Power Supply.

. Performing a Test

Follow these steps to perform a test.
CAUTION: Always place the monitor on a flat surface that is free of
vibration while you perform a test. DO NOT hold the monitor in your hand.
Failure to do so may cause inaccurate results.
1. Press and hold the button or insert a fresh test strip to turn the
monitor ON
The monitor will The monitor will prepare for
automatically perform a self a test for a few seconds.
test where all segments on
the display will appear.
to return to the monitor display where you
again to re-enter Setup
If you turned the monitor on
by pressing the button,
the monitor will prompt you
to insert a test strip (go to
step 2).
If you turned the monitor on
by inserting a fresh test strip,
the monitor will prompt you
to confirm the strip's code
(go to step 3).
EN
1