The Inratio2 Pt Monitor; System Description; Precautions And Limitations - HemoSense INRatio2 PT Benutzerhandbuch

EN
Contact HemoSense Technical Support if you have questions about using your system

correctly or if you are having problems with the monitor or strips.
Technical Support
1-877-436-6444 (toll free) or 1-408-719-1393
Technical support available 24 hours/day, 7 days/week
CAUTION: Contact your health care provider if you have questions about
your test results and any actions you should take.

. System Description

The INRatio2 PT Monitor

Top View
LCD Display
(OK) Button:
turns the monitor ON and OFF, and accepts/
stores display entries
(UP) and (DOWN) Buttons:
changes information on the display
and scrolls between results in the
monitor memory
(Memory) Button:
puts the monitor in Memory
mode
(Setup) Button: puts the monitor in Setup mode
Test Strip Guide: insert test strip here to turn monitor
ON for Testing
Sample Light: apply blood sample here after the test
strip is inserted
The INRatio2 PT Monitor
Top End and Bottom Views
Battery Door
Battery Door Release
Power Supply Jack

. Precautions and Limitations

Certain conditions limit the effectiveness of the INRatio2 PT Monitoring system to work
properly and provide accurate results. Take note of these limitations and precautions.
Care of your INRatio2 PT monitor
• DO NOT allow any liquid to spill on the monitor. If this should occur, unplug the
monitor (if it is plugged in) and call HemoSense Technical Support immediately.
• The monitor is a delicate instrument, and should be handled with care.
Dropping or other mishandling may cause it to malfunction.
• The monitor should be transported in its supplied carrying case or another secure
container.
• DO NOT store the monitor below -4
F/-20
º
Testing environment
• Room temperature for testing should be between 50
• The monitor and test strip must also be at room temperature before use.
• Relative humidity should be between 15% and 95%, without condensation.
• Atmospheric pressure should be between 700 hPa and 1060 hPa.
The Test Strip
Electrodes
Test Area
Data Port
Sample Well
C or above 158 F/70 C.
º º º
F and 95 F (between 10 C and 35
º º º
EN

C).
º