HemoSense INRatio2 PT Benutzerhandbuch Seite 7

EN
12
8. Change the hour 9. Change the minutes
The hour will be flashing on The minutes will be flashing
the display. Use the and on the display. Use the
buttons to change the hour. and buttons to change the
Press the button when minutes.
you have the correct hour on
the display.
10. Select the test result display mode
Use the and buttons to choose 1 of 4 different display modes.
This display mode controls how much information will appear
along with your INR test result on the monitor display. DO NOT
select either of the 2 display modes that show QC results (INR +
QC mode or INR + PT + QC mode). These 2 modes are for health
care providers only.
NOTE: Your test result in INR units will appear no matter which of the 4 display modes you select.
INR Mode
INR + PT Mode
Press the button when
you have the correct minutes
on the display.
INR Mode
Test results are displayed in
International Normalized Ratio
(INR) units only. The INR is a
mathematical correction of the
Prothrombin Time (PT) result
(Example result)
that adjusts for differences in
the reagents that are used in
calculating your test results.
INR + PT Mode
Test results are displayed in
International Normalized Ratio
(INR) units and Prothrombin
Time (PT) seconds.
(Example result)
Press the button when you have the correct display mode on the display.
11. Select the target range mode
An INR target range may be set in your monitor to alert you when your test results fall outside
the range.
CAUTION: Always contact your health care provider before setting an
INR target range that's appropriate for you. If your results fall outside the
target range, or if your results fall within the target range but are not
consistent with your current health status (e.g., you have symptoms such as
bleeding or bruising), follow your health care provider's instructions for the
correct action to take.
Use the the and buttons to switch between the Target ON and
OFF modes.
If you want the target range mode ON, press the
when the Target Range ON symbol (
step 12.
( = Target range mode ON)
If you want the target range mode OFF, press the
when the Target Range OFF symbol (
will return to the monitor display that prompts you to insert a test
strip. Skip steps 12 and 13.
12. Set the lower limit of the target range
The lower limit of the target range will be flashing, and the Low
Target symbol (
will also appear on your test result display whenever your result
falls below the lower limit. Use the and buttons to change the
lower limit.
Press the
the display.
button
) is on the display. Go to
button
) is on the display. You
( = Target Range mode OFF)
)will appear on the display. The "LO" message
button when you have the correct lower limit on
EN
1