Care And Cleaning Of Your Monitor; Troubleshooting Error Messages - HemoSense INRatio2 PT Benutzerhandbuch

EN

12. Care and Cleaning of your Monitor

2
Follow these steps to keep your monitor clean.
NOTE: No maintenance is required other than routine cleaning.
Clean the outside of the monitor with a clean damp cloth. If
necessary, a mild detergent or disinfectant (such as a 5% bleach
solution or 70% isopropyl alcohol) may be used.
Clean the area around the test strip guide with a swab or pad
that has been dampened with alcohol or 5% bleach solution.
1. Installing/Replacing Monitor Batteries
Follow these steps to install/replace the monitor batteries.
The monitor batteries should be replaced whenever the Low
Battery symbol ( ) appears with the flashing CAUTION symbol
( ) after turning the monitor ON. The batteries still have
enough power to perform a test but should be replaced as soon
as possible.
When both the Low Battery symbol ( ) and CAUTION symbol
( ) are flashing on any monitor display, it means the batteries
must be replaced as soon as possible. The monitor will turn OFF
after about 30 seconds.
1. Turn the monitor upside down so that the bottom
is facing you
2. Remove the battery door by pressing down on
the battery door release
3. Remove the old batteries and replace with 4
standard AA batteries
Follow the direction for battery placement (+ and – ends)
inside the battery compartment.
4. Replace the battery door
NOTE:
• Turning the monitor OFF manually when it is not being used will help conserve battery
power.
• Your settings for date, time, display mode, and target range will be saved as long as you
replace the batteries within about five hours of the Low Battery symbol first appearing on
the display.

1. Troubleshooting Error Messages

Follow these steps to resolve most problems that you might encounter.
Display Screen What it Means
Battery power is low.
However, there is still
enough power to perform
a test.
Battery power is very low.
There is not enough power
to perform a test, and the
monitor will turn off after
about 30 seconds.
Ambient temperature is too
cold (below the operating
range) for the monitor to
work properly.
EN
2
Action to Take
Replace batteries as soon
as possible.
Replace batteries
immediately.
Move the monitor to a
warmer location and try
again in a few minutes.