H) Modifying The Steering Direction - Reely SKY 22 93 80 Bedienungsanleitung

h) Modifying the steering directions
Your remote control is tuned ex works exactly to your double rotor electric powered helicopter.
However, if during trimming, you notice that your model helicopter, with individual steering functions,
responds contrary to the pattern illustrated in figure 5, then you can switch over at the transmitter the
direction of the response of the model for each individual steering function,.
To this effect, the transmitter is equipped on the rear side with 8 DIP switches (1), see figure 11, pos. 1.
Switches 1-4 are assigned the following functions:
DIP switch
1
2
3
4
Switches 5-8 do not have any function. pos. 2 in figure 11 is the transmitter crystal
To switch over a steering function, first disconnect the flight battery in the helicopter, then switch off
the transmitter and push the corresponding DIP switch in the other switch position. Now you can
switch on the transmitter again, connect the flight battery and check the correct function direction at
the helicopter.
Function
Tail Function
Roll Function
Nick Function
Pitch Function
Factory setting
OFF
ON
ON
ON
Figure 11
61