Reely SKY 22 93 80 Bedienungsanleitung Seite 56

Make sure that all four lateral panels are cor-
rectly guided in the corresponding rails and
that the steering trims (see fig. 1. pos. 8 and 9)
are correctly placed in the openings of the cas-
ing.
Finally check the mechanical function and
firmly screw the stick unit.
• Now place the lateral panel that was removed
from the right stick unit (without reset lever and
spring) following the same steps at the left
stick unit.
Here also the steering trims (see fig. 1, pos. 5
and 6) must be placed correctly in the open-
ings of the casing.
The stop spring (9) must be fastened to the left
upper screw (2).
• Now exchange the connecting lines (13 and 14)
of the two control stick potentiometers.
To that effect, disconnect the two connectors
of the connecting cables (15 and 16), which are
protected against polarity reversal at the main
board, then reconnect them interchanged.
Both cables do not run crossed any more; they
run parallel from the stick unit to the main
board.
Now you can fold out the cover of the transmitter again, insert the plug of the LED voltage display (12)
and screw together the casing of the transmitter. Finally, screw the antenna on again and place the
battery compartment.
56
Figure 6c
Figure 6d