Reely SKY 22 93 80 Bedienungsanleitung Seite 64

Upper rotor circuit:
• The angles of attack of the rotor blades in the
upper rotor area are determined primarily by
the position of the flyball rod (1).
• If the rotor blade (2) at the left of the steering
linkage (3) runs too high, the linkage at the
lower attachment point (4) must be unhinged
and lengthened by a half rotation.
• If the rotor blade runs too low, the linkage must
be shortened by a half rotation.
• Repeat this procedure until the upper rotor
shows a correct alignment as well.
Both setting screws (5) must be tightened
firmly.
Note!
Make sure after the modification of the length of the linkage to set the eyelets of the
linkage in an angle of 40-45° to each other.
64
Figure 13