Setting The Cutting Depth - Cocraft HC1400 Bedienungsanleitung

Settings
Warning
Always unplug the saw before making any adjustments or servicing it.

Setting the cutting depth

1. Undo the locking lever (18).
2. Set the base plate (9) to the desired cutting
depth using the scale as a guide.
3. Tighten the locking lever.
Setting the base plate bevel angle (tilt)
1. Undo the locking knob (4).
2. Set the desired angle (0–45°) using
the scale.
3. Tighten the locking knob.
4. Check the angle and adjust if necessary.
Adjusting the parallel guide
1. Undo the locking knob (6).
2. Set the desired width.
3. Tighten the locking knob.
4. Measure the distance between the parallel
guide and the saw blade to check
the setting.
11