c) Replacing the Linkage Rods
If the linkage rods of the top rotor must be replaced,
work very carefully and applying as little force as
possible.
Use tweezers or small pointed pliers to remove the
linkage rods or apply it again.
If the ball pins (2) are damaged by a crash, the linkage
rods may also be installed on the opposite side (3).
Important!
When replacing mechanical parts use only original spares available from the manufacturer.
The spare parts list is located on our website www.conrad.com in the download section to the respective product.
You can also order the replacement parts list by phone. For contact information, please refer to chapter "1. Introduction"
at the beginning of these operating instructions.
40
Figure 15