C) Operation - VOLTCRAFT T6200 Bedienungsanleitung

c) Operation

• This charger must only be used to charge the rechargeable battery types indicated in the chapter
„Technical Data" with the corresponding cell number.
Never charge any other rechargeable batteries (e.g. NiZn, NiFe or LiMn) or even normal batteries.
There is great danger of fire or explosion!
• Maintain enough distance from flammable objects. Leave enough distance (at least 20 cm) between the
charger and the rechargeable battery - never place the rechargeable battery on the charger.
• As both the charger and the battery heat up during the charge/discharge procedure, it is necessary to
ensure sufficient ventilation. Never cover the charger and/or the connected rechargeable battery.
• Do not operate the product unattended. Despite a considerable number of protective circuits, it is
impossible to exclude the possibility of malfunctions or problems during the charging process.
• Do not wear any metal or conductive materials, such as jewellery (necklaces, bracelets, rings, etc.)
while you are working with the charger or batteries at the rechargeable battery or charger.
• Do not leave rechargeable batteries connected to the charger when the charger is not needed. Always
disconnect the rechargeable battery from the charging cable and then the charging cable from the
charger.
Disconnect the charger from the voltage source and then keep the product in a clean, dry location.
• Never use the charging cable with the rechargeable battery while the charging cable is not connected
to the charger. Danger of short circuit.
• Only operate the product in moderate climate, never in tropical climate. For more information on accep-
table environmental conditions, see the chapter „Technical Data".
• Never operate the device immediately after it was taken from a cold room to a warm room. The resul-
ting condensation may lead to malfunctions or damage!
Allow the charger (and the rechargeable battery/batteries) to reach room temperature before connec-
ting the charger to the power supply and using it. This may take several hours!
• Handle the product with care. Impact, blows, mechanical pressure, vibrations or falls from even a low
height will damage the product.
• If you have reason to believe that the device can no longer be operated safely, disconnect it immediate-
ly and make sure it is not unintentionally operated.
It can be assumed that operation without danger is no longer possible if the device has any visible da-
mage, the device no longer works, after extended storage under unsuitable conditions or after difficult
transport conditions.
40