Operation; Specifications - VOLTCRAFT VC 5000-2 Bedienungsanleitung

Operation

Fully charge the power banks before first use.
Never charge the power banks while charging a mobile device.
Ensure that the connection specifications for your mobile device match the
connection specifications for the product (see 'Technical data').
Always read the operating instructions for your mobile device.
Do not short circuit the USB input/output of the power bank.
a) Checking the charge status
Briefly press the function button (3) to check the charge status of a power bank. The charge
status indicator (2) shows a running light and the power bank checks the battery. The LEDs
then indicate the charge status.
• 1 LED lit = 0-25%
• 2 LEDs lit = 25-50 %
• 3 LEDs lit = 50-75 %
• 4 LEDs lit = 75-100 %
If no USB device is connected for charging, the charge status indicator (2) goes out
again after a few seconds.
b) Charging the power banks
Proceed as follows to charge the power banks:
• Disconnect any connected mobile devices from the power bank.
input (6) of the charging station to a suitable USB power source
• Connect the USB-C
TM
(max. 5 V/3 A). To do this, use the supplied USB-A to USB-C
USB-C cable.
TM
• Insert one (or both) power bank(s) into the charging station in such a way that a USB-C
charging port (5) of the charging station is inserted into the USB-C
power bank (1).
The charging time for the simultaneous charging of both power banks is approx.
4 hours for a charger with 5 V/3 A.
Alternatively, you can also charge the power banks by connecting the supplied
USB-A to USB-C cable or USB-C
TM
input/output on the power bank (1).
• The charge status indicator (2) flashes during charging as follows:
0-25 % 25-50 %
LED 1 flashes lights up
LED 2 off flashes
LED 3
off
LED 4 off
• Disconnect the cable from the product and the power source as soon as the power bank
is fully charged.
If you only use the power banks occasionally, we recommend that you fully charge
them every 6 months in order to retain maximum capacity.
c) Charging mobile devices
To charge mobile devices with the power banks, proceed as follows:
• Disconnect the power bank from the power supply or remove the power bank from the
charging station.
• The power bank has two charging ports:
- USB-C output (1)
TM
- USB-A output (4)
• Each of the charging ports can be connected to a corresponding mobile device
(e.g. a smartphone). You can use both charging ports at the same time.
• Connect the mobile device to one of the two charging ports. To do this, use the supplied
USB-A to USB-C cable or USB-C
TM
• If the charging process does not start automatically, briefly press the control button to switch
the power bank on. The LEDs of the charge status indicator (2) light up and indicate the
current charge status of the power bank (see also Section „a) Checking the charge status").
• Monitor the charging process. The power bank switches itself off as soon as the mobile
device has finished charging (or the power bank battery is empty).
• To terminate the charging process manually, disconnect the cable connection between the
power bank and the mobile device. The power bank switches off automatically after a few
seconds and the LEDs of the charge status indicator (2) go out.
cable or USB-C
TM
TM
to USB-C cable directly to the USB-C
TM TM
50-75 % 75-99 %
lights up lights up
lights up lights up
off flashes lights up
off off flashes
to USB-C cable.
TM TM
Care and cleaning
Do not use any aggressive cleaning agents, rubbing alcohol or other chemical
solutions, as these may damage the housing or impair the functioning of the device.
• Remove the product from the power supply and the connected devices before cleaning.
• Use a dry, lint-free cloth to clean the product. Do not allow water to get inside the housing.
• To prevent scratch marks, do not press too strongly on the surface when cleaning.
Disposal
a) Product
Electronic devices are recyclable waste and must not be placed in household waste.
At the end of its service life, dispose of the product according to the relevant statutory
regulations. Remove any inserted batteries and dispose of them separately from the
product.
b) Batteries
As the end user, you are required by law (Battery Directive) to return all used
batteries. They must not be placed in household waste. Batteries containing
hazardous substances are labelled with this symbol to indicate that disposal in
household waste is forbidden. The abbreviations for heavy metals in batteries are:
Cd = Cadmium, Hg = Mercury, Pb = Lead (indicated on the battery, e.g. below the
waste icon on the left).
Used batteries can be returned to local collection points, our stores or battery
retailers.
You thus fulfil your statutory obligations and contribute to environmental protection.
to
TM

Specifications

Power banks
TM
input/output of the
Input voltage/current ..................5 V/DC, 2.4 A (USB-C
Output voltage/current ...............5 V/DC, 2.4 A (USB-C
Charging station
Input voltage/current ..................5 V/DC, max. 3 A (USB-C
Output voltage/current ...............5 V/DC, 2.1 A (USB-C
TM
Rechargeable battery ...................Li-ion, 3.7 V 5000 mAh
Charging time ...............................approx. 4 h (charging of both power banks in the charging
Operating conditions ..................... 0 to +45 °C, max. 80 % relative humidity
100 %
Storage conditions ........................0 to +45 °C, max. 80 % relative humidity
lights up
Dimensions (W x H x D)
lights up
Power banks ..............................75 x 35.5 x 25.5 mm each
Charging station ........................85 x 50 x 25 mm
lights up
Length of the supplied charging cable
lights up
USB-A to USB-C
USB-C to USB-C
TM
Weight
Power banks ..............................96 g each
Charging station ........................31 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or capture in electronic
data processing systems, requires the prior written approval of the publisher. Reprinting, also in part, is prohibited. This
publication reflects the technical status at the time of printing.
Copyright 2021 by Conrad Electronic SE.
TM
TM
TM
station)
cable ...........60 cm
TM
cable .......60 cm
TM
)
/USB-A)
input)
TM
output 1/2)
*2357058_v2_0621_02_DS_m_4L_(1)