Grass Bag Cleaning And Replacement - Honda HRX537VKE Betriebsanleitung

Installation
1. Clean dirt and grass from around the blade mounting area.
2. Install both blades [3] and [4] using the two blade bolts [1] and
special washers [2] as shown. Be sure to install the special
washers with the concave side toward the blades and the convex
side toward the head of the bolt.

Operating this mower with only one blade will result in
an improperly seated blade that can be thrown from
the mower and seriously hurt or kill someone.
Always install both blades as a set.
The blade bolts are specially designed for this application and
must not be replaced with other bolts.
3. Tighten the blade bolts with a torque wrench [7]. Use a wooden
block [6] to prevent the blades from turning.
[6]
[7]
Blade bolt torque: 49 ~ 59 N·m
If you do not have a torque wrench, have an authorized Honda
dealer tighten the blade bolts before you use the mower. If the
blade bolts are overtightened, they could break. If the blade bolts
are not tightened enough, they could loosen or come out. In either
case, it would be possible for the blades to fly off while you are
operating the mower.
WARNING
[3] [4]

GRASS BAG CLEANING AND REPLACEMENT

Grass Bag Cleaning
Wash the bag with a garden hose, and allow it to dry completely
before use; a wet bag will clog quickly.
Grass Bag Replacement
Replace a worn or damaged bag with a Honda replacement bag or its
equivalent.
Bag Removal
1. Unclip the plastic edges [1]
of the bag [2] from the
frame [3].
2. Remove the bag from the
frame.
Bag Installation
1. Insert the bag frame [3] into the
bag [2], as shown above.
2. Clip the plastic edges [1] of the
[2]
bag onto the frame.
[1]
OPERATION CHECK OF THE BLADE CONTROL
Start the engine outdoors. Release the blade control lever; the engine
should stop quickly. If the engine does not stop quickly, take the
mower to an authorized Honda servicing dealer for repair.
ENGLISH
[2]
[3]
[1]
[1]
15