Maintenance; Maintenance Safety - Honda HRX537VKE Betriebsanleitung

Dry Grass
If the ground is too dry, mowing will stir up a lot of dust. Besides being
unpleasant to work in, too much dust will clog the carburetor air filter.
If dust is a problem, water your lawn the day before mowing. Mow
when the grass is dry to your touch, but the soil is still moist.
Wet Grass
Wet grass is slippery and can make you lose your footing. Also, wet
grass clippings will clog the mower deck and collect in clumps on the
lawn. Always wait for wet grass to dry before mowing.
Fallen Leaves
Your mower can be used to pick up fallen leaves for disposal. If using
the mower to bag large amounts of fallen leaves and not for mowing,
set the cutting height adjustment levers so the front of the mower
deck is one or two settings higher than the rear.
To start, position the Clip Director knob in the #9 position (not quite full
mulching). This setting will allow the leaves to be recirculated and
recut until the particles are small enough to pass though the sliding
door opening and into the grass bag. Depending on the size, type,
and water content of the leaves, it may be necessary to open the
sliding door to allow for best bagging results. Using the sliding door
correctly will allow better grass bag filling, resulting in less grass bag
emptying. Be sure there are no obstacles, including rocks, hidden
under the leaves.
If you want to mulch fallen leaves into your lawn, don't let the leaf
cover get too deep before you begin. For best results, start mulching
while grass still shows through the leaf cover. Position the Clip
Director knob in the MULCH position. In places where fallen leaves
completely cover the grass, remove the leaves by raking, or use the
grass bag so your mower can pick them up for disposal.
Clogged Mower Deck
Before clearing a clogged mower deck, stop the engine and turn the
fuel valve to the OFF position. With the spark plug cap disconnected,
tilt the mower so the air cleaner side is up.
Clear a clogged deck with a stick, not your hands.
Mowing Patterns
Your Honda mower will work most efficiently if you use the following
mowing patterns as much as possible. Mower deck and equipment
design, and the direction in which the blades rotate, cause these
mowing patterns to give the best results.
Mulching
Use a counterclockwise mowing
pattern when the Clip Director
knob is in the full MULCH
position. If the lawn has an
irregular shape, or many
obstacles, divide it into sections
where you can use
counterclockwise mowing
patterns.
MULCHING PATTERN
ENGLISH
Bagging
Use a clockwise mowing pattern.
This will give the best Clip Director
and bagging performance, leaving
the least amount of clippings on the
lawn.
Rear Discharge Mowing
Remove the grass bag and close
the discharge guard. Adjust the Clip
Director knob to the desired setting
and begin mowing in a clockwise
mowing pattern. If the lawn has an
irregular shape, or many obstacles,
divide it into sections.

MAINTENANCE

Good maintenance is essential for safe, economical, and trouble-free
operation. It will also help reduce air pollution.
To help you properly care for your mower, the following pages include
a maintenance schedule, routine inspection procedures, and simple
maintenance procedures using basic hand tools. Other service tasks
that are more difficult, or require special tools, are best handled by
professionals and are normally performed by a Honda technician or
other qualified mechanic.
The maintenance schedule applies to normal operating conditions. If
you operate your mower under unusual conditions, consult an
authorized Honda dealer for recommendations applicable to your
individual needs and use.
Remember that your Honda dealer knows your mower best and is
fully equipped to maintain and repair it.
To ensure the best quality and reliability, use only new, Honda
Genuine parts or their equivalents for repair and replacement.

Improper maintenance, or failure to correct a problem
before operation, can cause a malfunction in which you
can be seriously hurt or killed.
Always follow the inspection and maintenance
recommendations and schedules in this owner's
manual.

MAINTENANCE SAFETY

Some of the most important safety precautions follow. However, we
cannot warn you of every conceivable hazard that can arise in
performing maintenance. Only you can decide whether or not you
should perform a given task.

Failure to properly follow maintenance instructions and
precautions can cause you to be seriously hurt or
killed.
Always follow the procedures and precautions in this
owner's manual.
Safety Precautions
• Make sure the engine is off before you begin any maintenance or
repairs. This will eliminate several potential hazards:
BAGGING & REAR-DISCHARGE
PATTERN
WARNING
WARNING
11