Controls; Pre-Operation Checks - Honda HRX537VKE Betriebsanleitung

CONTROLS

FUEL VALVE
The fuel valve [1] opens and closes the
connection between the fuel tank and the
carburetor.
SMART DRIVE CONTROL
The Smart Drive control [1] can
be adjusted up or down into
any one of five positions.
1. Slide the multi-position
adjuster [2] to the left to
unlock the control.
2. Move the Smart Drive
control up or down into the
most comfortable position
3. Release the multi-position
adjuster and allow it to engage.
Do not attempt to adjust the position of the Smart Drive control
while the mower is in motion.
CUTTING HEIGHT ADJUSTMENT LEVERS
There are seven adjustment
settings. The cutting height
figures are approximate. The
actual height of cut grass will
vary with lawn and soil
conditions.
There is one adjustment
lever [1] for each wheel.
CLIP DIRECTOR
KNOB
The Clip Director knob [1]
controls bagging,
mulching, and rear
discharge. The knob has
ten adjustment positions.
OFF
ON
[2]
20 mm
32 mm
46 mm
62 mm
[1]
[1]

PRE-OPERATION CHECKS

CHECK YOUR LAWN
For your safety and for the safety of others, always inspect the area
before mowing.
Objects
Anything that can be picked up by the blades and thrown is a potential
hazard to you and others. Look for things like stones, sticks, bones,
and wire. Remove them from the mowing area.
People and Pets
[1]
People and animals near the mowing area can move into your path or
into a position where they could be struck by thrown objects. Clear the
area of people, especially children, and pets. Their safety is your
[1]
responsibility.
Lawn
Check the length and condition of the grass, so that you will know
what cutting height and mowing speed to use.
Avoid mowing wet grass. Not only will wet grass clog your mower
deck and collect in clumps on the lawn, it also gives poor traction,
increasing your risk of losing your footing.
CHECK YOUR MOWER
Blades
1. Move the fuel valve to the
OFF position (page 5) and
disconnect the spark plug cap
from the spark plug (page 13).
2. Tilt the mower to the right so
the fuel cap is up [1]. This will
help prevent fuel leakage,
motor oil seeping into the air
filter, and hard starting.
75 mm 3. Inspect the blades [2] for
damage, cracks, and
88 mm
excessive wear, rust, or
corrosion.
100 mm
WORN
NORMAL
ENGLISH
[2]
BENT CRACKED
[1]
NORMAL
EXCESSIVELY
WORN
5