Honda HRX537VKE Betriebsanleitung Seite 14

Spark Arrester Service
In Europe and other countries where machinery directive 2006/42/EC
is enforced, this cleaning should be done by your servicing dealer.
The spark arrester must be serviced every 100 hours to keep it
functioning as designed.
1. Allow the engine to cool, and then remove the three bolts [1] from
the muffler shield [2] using a 10 mm socket wrench.
2. Remove the muffler shield [2].
3. Remove the screw [4].
4. Remove the spark arrester [3] from the muffler [5].
5. Check for carbon deposits on the spark arrester and the exhaust
port. Brush carbon deposits away. Be careful to avoid damaging
the spark arrester screen.
6. Install the spark arrester in the muffler.
7. Install the muffler components on the engine, and tighten the three
bolts securely.
[3]
[2]
[1]
14
BLADE REMOVAL AND INSTALLATION
If you remove the blades for sharpening or replacement, you will need
a torque wrench for installation. Wear heavy gloves to protect your
hands.
BLADE SHARPENING: To avoid weakening the blades, or causing
imbalance or poor cutting, the blades should be sharpened by trained
staff at an authorized Honda dealer.
BLADE REPLACEMENT: Use Honda Genuine replacement blades or
their equivalent.
Removal
1. Turn the fuel valve OFF and disconnect the spark plug cap.
2. Tilt the mower to the right so the fuel cap is up. This will help to
3. Use a 14 mm (6 point) socket wrench and remove the two blade
[4]
[1]
[5]
4. Remove the upper [4] and lower blades [3].
ENGLISH
prevent fuel leakage, motor oil seeping into the air filter, and hard
starting.
bolts [1] and special washers [2] from the flywheel brake assembly
[5]. Use a wooden block to prevent the blades from turning when
removing the bolts.
[4]
[3]
[2]
[5]