Herunterladen Inhalt Inhalt Diese Seite drucken
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 59

SET-UP

UNPACKING
Remove all the cardboard from around the handlebar.
HANDLEBAR SETUP
[3]
1. Turn the handlebar adjust knobs [2] 90 degrees into the unlock
position [3].
2. Hold the flywheel brake lever [1] against the handlebar, and unfold
the handlebar into the mowing position.
3. Move the handlebar up or down, so the locating pins align with
either the higher, middle, or lower holes on the handlebar
mounting brackets.
4. Turn the adjusting knobs 90 degrees into the lock position [4], and
the pins will spring into the holes and lock into position.
GRASS BAG ASSEMBLY
Slide the grass bag frame [1] into the grass bag [2] and install the
plastic clips [3] as shown.
[1]
4
[1]
[2] (2)
[4]
[2]
[3]
Lift the discharge guard
and install the grass
bag.
ENGINE OIL
The mower is shipped
WITHOUT OIL in the engine.
Add enough SAE 10W-30
API service category SJ or
later oil to bring the oil level
between the upper limit [2]
and lower limit [3] marks on
the dipstick [1] as shown.
Do not overfill the engine
with oil. If the engine is
overfilled, the excess oil may
get transferred to the air
cleaner housing and air filter.
FUEL
Refer to page 6.
BEFORE USING YOUR LAWN MOWER
Before using the lawn mower, all mower operators must read the
following chapters:
• SAFETY INSTRUCTIONS (page 2)
• CONTROLS (page 5)
• PRE-OPERATION CHECKS (page 5)
• OPERATION (page 9)
• MAINTENANCE SCHEDULE (page 12)
ENGLISH
[1]
[2]
[3]

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis