Grass Catcher Cleaning And Replacement; Replacing A Fuse (Hzea); Operation Check Of The Cutting-Means Control - Honda HRX537C Bedienungsanleitung

Cutting-means Replacement
CAUTION:
• Cutting-means balance is critical to proper lawnmower performance.
Replace any cutting means that is damaged or out of balance.
• Use only genuine Honda replacement cutting means.
Cutting-means Sharpening
CAUTION:
• To avoid weakening the cutting means, causing it to become unbalanced or
getting a bad quality of cut, the cutting means should be sharpened by
competent personnel at your servicing dealer.
1. Sharpen the cutting means cutting edges with a file. File the top side
only. Maintain the original bevel for a fine cutting edge. File both ends
evenly to maintain cutting-means balance.
2. After sharpening, test the cutting-means balance using a screwdriver
as shown above. If either side dips slightly below the horizontal, file
that side. Replace the cutting means if it dips excessively.
15 mm
Max.
GRASS CATCHER CLEANING AND
REPLACEMENT
Cleaning
Wash the catcher with a garden hose, and allow it to dry completely
before use; a wet catcher will clog quickly.
Replacement
Replace a worn or damaged catcher with a Honda replacement catcher or
its equivalent.
Removal
1. Unclip the plastic edges [1] of
the catcher [2] from the frame
[3].
2. Remove the catcher from the
frame.
7 mm
Max.
C12
SAFETY
[3]
[2]
[1]
Installation
1. Insert the catcher frame [3] into the
catcher [2], as shown above.
2. Clip the plastic edges [1] of the
catcher onto the frame.

REPLACING A FUSE (HZEA)

The electric starter circuit and battery are protected by a 30 amp SLO-BLO
fuse [1] and 3 amp fuse [2]. If the 30 amp fuse burns out, the electric starter
will not operate and if the 3 amp fuse burns out, the battery will not
charge. The engine can be started manually if either fuse burns out.
1. Remove the battery cover by removing the three cover mounting
screws [3].
2. Remove and inspect the fuses. If they are burned out, replace with the
correct fuse.
NOTICE
• The 3 Amp fuse is a "slow blow" fuse design. Do not replace with a standard
fuse, or frequent fuse failure may occur.
• Never use a fuse with a rating other than shown. Serious damage to the
electrical system or a fire can result.
If a frequent fuse failure occurs, it usually indicates a short circuit or an
overload in the electrical system. Take the mower to an authorized Honda
servicing dealer for repair.

OPERATION CHECK OF THE CUTTING-MEANS CONTROL

D6 Start the engine outdoors. Release the cutting-means control lever; the
engine should stop quickly. If the engine does not stop quickly, take the
mower to an authorized Honda servicing dealer for repair.
[3]
[1]
[2]
[3]
[1]
[2]
17 EN