Honda HRX537VKE Betriebsanleitung Seite 8

Cutting Height
Check the mower deck
cutting height settings,
and be sure that all four
adjustment levers [1] are
set to the same cutting
height position.
To adjust cutting height,
pull each adjustment lever
[1] toward the wheel, and
move it into another notch.
If you are not sure what
cutting height to select,
start with a high setting
and check the appearance
of the lawn after mowing a
small area. Then readjust
cutting height if necessary.
Clip Direction
Clip Director Knob
Adjustment
Adjust the Clip Director knob [1] in any one of the ten positions to
achieve the desired mowing results.
To adjust the Clip Director knob, pull the knob downward and towards
the rear of the mower. The knob adjusts a sliding door [2] from the
fully open BAG position to the fully closed MULCH position (see the
following page).
[1]
IMPORTANT SAFETY PRECAUTION
Always turn the engine off and disconnect the spark plug cap before
lifting the discharge guard to view or clean around the sliding door.
This will prevent contact with the rotating blades and prevent objects
from being thrown into the discharge area.
Some grass accumulation in the discharge opening is normal when
the Clip Director is fully closed. To remove this grass, close the
discharge guard, fully open the Clip Director, and start the engine.
If a high resistance is noticed when moving the Clip Director knob
from side-to-side, excessive grass may have built up on top of the
sliding door.
Sliding Door Position
The sliding door [2] can be positioned to produce different mowing
results. If the preferred sliding door position is unknown, install a
grass bag and begin mowing with the Clip Director knob [1] all the
way to the BAG position. Check the appearance of the lawn. As the
knob is moved towards the MULCH position, more grass will be
8
[1]
20 mm
[1]
32 mm
46 mm
62 mm
DISCHARGE
[2] (fully closed)
recycled back into the lawn. Adjust the Clip Director knob until the
desired result is achieved.
[1]
75 mm
88 mm
FULL BAGGING OR
100 mm
REAR DISCHARGE
[1] (BAG position)
[2] (fully open)
Rear Discharge
To discharge clippings to the
rear, remove the grass bag
and position the Clip Director
knob [1] in the BAG range.
GUARD
Maximum rear discharge
will occur when the Clip
Director knob is all the way
to the left (BAG) position.
As the Clip Director knob is
moved toward the right
(MULCH) position, less
grass will be discharged
though the rear discharge
guard.
Are You Ready to
Mow?
Be sure to wear protective clothing. Long pants and eye protection
can lower your risk of injury from thrown objects. Wear footwear that
protects your feet and won't let you slip if you mow on slopes or
uneven ground.
ENGLISH
BAGGING OR REAR DISCHARGE
AND SOME MULCHING
[2] (50% open)
FULL MULCHING
[1] (MULCH position)
[2] (fully closed)
[1]