Flyer C SERIE Originalbetriebsanleitung Seite 408

Backlight blinks.
Backlight blinks.
Console Description
Battery communication error
– C ommunication with the battery is
not being performed successfully.
Overheating (motor)
– T he mode has entered the protection
mode since the motor unit is over-
loaded.
Overheating (battery)
– T he mode has entered the protection
mode since the battery is overloaded.
Bicycle mark button
Walk assistance) error
– E ither the bicycle mark button (Walk
assistance) is pressed or short-
circuited.
Motor unit error
– T he motor unit is in error.
Is the electric wire connector cor-
rectly installed?
Maintenance request
– T he devices related to Di2 have an
error.
Average speed error
– T here is not enough data to calculate
the average speed.
EEPROM error
– T he console has an error.
Entire display blinks.
Entire display blinks.
Entire display blinks.
Entire display blinks.
Entire display blinks.
Entire display blinks.
Entire display blinks.
Protective function active
– T he protective function against the
continuous charging is activated.
Coin-type battery out of power
– T he coin-type battery has run out
of power.
Remedy
Remove any dirt from the battery terminals. If this does
not remedy the problem, take the electric bicycle to your
dealer.
Travel under a lighter load. After a short while,
the temperature will return to normal and the assist
function will be restored.
Travel under a lighter load. After a short while,
the temperature will return to normal and the assist
function will be restored.
Check that the bicycle mark button (Walk assistance) is
not pressed, and press the power button to turn the power
back on again. If this does not remedy the problem, take
the electric bicycle to your dealer
Take the electric bicycle to your dealer.
Check if the electric wire connector is
disconnected.
Take the electric bicycle to your dealer.
Update the fi rmware and clear any errors of each individual
component and the system by connecting the PC and
bicycle (system or components) using the PC connected
device, and using E-tube Project that is published by
SHIMANO INC.
Reset the average speed.
* Measurement data such as distance travelled is not
recorded while [E] is still displayed, though the power
assist function is active.
Take the electric bicycle to your dealer.
Turn the power off and on. If the display does not
disappear even when the power is turned off and on,
your device is the unsupported USB device.
Replace the coin-type battery and set the time.
EN-31
EN