Flyer C SERIE Originalbetriebsanleitung Seite 141

Loading the battery
The battery can be charged while it is installed in
the e-bike or once it has been removed.
1) Remove the rubber cap
Open the rubber cap on the battery.
Connect the mains plug to a mains socket (220
V - 240 V AC) and connect the charger to the
battery.
Do not connect the charger to the mains
socket immediately after a sudden tem-
perature change from cold to warm. It is
possible that condensed water has col-
lected on the contacts and this will lead
to a short circuit. Do not connect the bat-
tery to the charger immediately after a
sudden temperature change from cold to
warm. Wait until both devices have
reached room temperature before con-
necting the charger or the battery. Al-
ways charge and store the battery and
the charger in a dry and clean environ-
ment.
2) Check the LED charge status indicator
Check whether the charge status LED is lit up.
The LED lights up according to the charge status.
The charge status LED goes off when the charg-
ing process has been completed.
The charging time takes longer if the
battery temperature is too low or too
high.
A fully charged battery cannot be charged any
further.
The battery may not be recharged when
it indicates a fault. The battery might be
damaged after being dropped or due to
mechanical impact, even when there is
no visible external damage. Such batter-
ies must therefore be inspected by a
FLYER specialist retailer. Never try to
open a battery or to repair it.
3) Remove the plug from the power outlet
Separate the mains plug from the mains socket
after disconnecting the battery from the charger.
It is important that the rubber cap is fi rmly reat-
tached before using the battery.
Safety warning regarding the battery charger
The name plate refers to warning notes and other
safety information in connection with handling the
charger. It is important to read them before using
the charger.
Charger
Use only the original Panasonic
charger supplied along with your
e-bike. Only this charger is designed for
the lithium-ion battery used on your
e-bike.
Completely charge the battery using the
charger before the fi rst ride to ensure full
battery performance. Read and adhere
to the operating instructions for the
charger when loading the battery.
The battery can at any time be charged outside
or installed in the bicycle without reducing its life
span. Interrupting the charging process does not
damage the battery.
The battery is equipped with a temperature moni-
tor that permits charging only within a tempera-
ture range of 0 °C to 40 °C. If the battery temper-
ature is too high, the battery will not charge. In
addition, if you press the control button for the
LED battery charge level, the LED at the very top
[F] and bottom [E] will blink.
Separate the battery from the charger and wait
until it has reached operating temperature. Only
reconnect the charger when it has reached the
permitted operating temperature.
139
Protective cap
EN