KEB COMBIVERT F4-F Betriebsanleitung Seite 71

Output Condition OUT D2
4. Parameter Description
Parameter CP.22 determines the output condition of digital output
D2 (terminal X2.9). ! see table below !
Adjustment Range:
Resolution:
Factory setting:
Value D1 and D2 Switching conditions
0 always inactive
1 always active
2 ready for operation; no malfunction (operating state: ready)
3 ready for operation; control release (terminal X2.1) given;
modulation enabled (operating state: run)
4 abnormal operating state or error (status A.xx or E.xx)
5 error (only status E.xx)
6 - reserved -
7 after the motor positive temperature coefficient is triggered
8 after the motor positive temperature coefficient is triggered
9 current controller restricted
10 speed controller restricted
11 any controller restricted
12 drive accelerates
13 drive decelerates
14 drive runs with constant speed
15 drive runs with contstant speed > speed 0
16 forward – not with noP, LS, Abnormal Stopping or error
17 reverse – not with noP, LS, Abnormal Stopping or error
only digital output D1
18 - reserved -
19 - reserved -
20 torque > torque level
21
22
23
24 overload prewarning: overload counter > 80 %
25 overload prewarning: overload counter > 40 %
26 prewarning: "heat sink temperature"
27 - reserved -
28 - reserved -
29 overload 2 - prewarning (refer to Instruction Manual Part 2)
30
31
32
33 error (only status E.xx)
1) Only during closed-loop operation (CP.32 = 1) !
Hysteresis
of the torque level
of the speed level
0...28
1
18
only digital output D2
actual speed > speed level
- reserved -
1)
- reserved -
- reserved -
- reserved -
- reserved -
speed reference displ. > speed level
system deviation > speed level
- reserved -
- reserved -
- reserved -
: 5% of M motor adjusted in the factory
N
(see page GB 35)
: 10 rpm
ANTRIEBSTECHNIK
GB
1)
GB 29