KEB COMBIVERT F4-F Betriebsanleitung Seite 65

P-Factor Speed Controller
I-Factor Speed Controller
Encoder 1 (inc/r)
4. Parameter Description
Input Speed Ratio
I1 / I2
is Actual speed dis. (CP.1) <
activated Jogging speed (CP.11)
is Actual speed dis. (CP.1) >
activated Jogging speed (CP.11)
is Speed reference dis. (CP.6) < drive decelerates on
deactivated Jogging speed (CP.11)
is Speed reference dis. (CP.6) > drive accelerates in accord.
deactivated Jogging speed (CP.11)
Proportional factor of the speed controller.
Adjustment assistance found in chapter "Startup page GB 40 / D 41.
Adjustment Range:
Resolution:
Factory setting:
! see also parameter CP.36 !
Integral factor of the speed controller.
Adjustment assistance found in chapter "Startup page GB 40 / D 41.
Adjustment Range:
Resolution:
Factory setting:
! see also parameter CP.36 !
Adjusts the increments of the incremental encoder used. Check the
set and actual speed displays during open-loop operation and
compare.
The correct setting is: actual speed = set speed - slip
Adjustment Range:
Resolution:
Factory setting:
Acceleration/
Deceleration Performance
drive accelerates on
the torque limit
drive accelerates in accord.
with the adjusted ramp
the torque limit
with the adjusted ramp
0...65535
1
400
0...65535
1
200
256...10000
1
2500
ANTRIEBSTECHNIK
GB
GB 23