Commissioning; Commissioning The Telephone - Auerswald Comfortel 2600 Inbetriebnahmeanweisungen

Commissioning

This section describes how to commission the telephone and the answering machine on the
COMfortel 2600 for the first time in a stepwise procedure. After a successful initial commis-
sioning, you will be able to make calls. You can customise your telephone and the answering
machine using the PC configuration described at the end of this section.

Commissioning the Telephone

Requirements
– PBX, switched on (connected to 230 V mains)
– The internal telephone number for the telephone entered in the configura-
tion on the internal S
Note: Only connect one ISDN device for each internal subscriber tele-
phone number to your PBX.
– For the operation with COMfortel Xtension300 key extension modules: the
wall-mounted power supply type No. FW7577/EU/40
– For the operation without COMfortel Xtension300 key extension modules:
The bridge plug is inserted into the jack marked with
of the telephone
– The PBX with at least the following firmware version:
Note: If you have devices with older firmware versions, carry out the corre-
sponding device updates (see instructions of the PBX).
1.
Insert the plug of the ISDN cable included in the package into the jack
marked with
2.
Insert the other ISDN cable plug into the ISDN socket connected to the
PBX.
3.
If required, insert the wall-mounted power supply type no. FW7577/EU/40
into a freely-accessible 230 V mains socket.
50
Commissioning
0
COMpact 3000: 4.0I
COMpact 2206 USB und COMpact 4410 USB: 2.4A
COMpact 5010 VoIP, COMpact 5020 VoIP, COMmander Basic.2 und
COMmander Business: 4.2A
COMmander 6000/R/RX: 5.4B
on the bottom of the telephone (see
The telephone starts up. In the meantime, the Auerswald company icon
is shown on the display.
COMfortel 1600/2600 - Firmware Version 1.2A - COMfortel Set 3.4 - Setup V04 09/2013
or U port on the PBX
P0
at the lower side
Fig. 10).