This section describes the commissioning of the telephone. After a successful commission-
ing, you can make calls. You can customise your telephone using the PC configuration
described at the end of this section.
Default settings when the equipment is supplied
–
Access data for the Configuration Manager:
i
i
–
Access data for the advanced settings in the telephone:
i
–
Network settings:
i
–
Network addresses (If no DHCP server is available in the network):
i
i
Connecting the COMfortel 1200 IP
Note: To integrate the telephone into an existing network, please contact
the system administrator responsible for this. Making changes to an exist-
ing network can cause considerable malfunctions.
Requirements
–
The network cable delivered with the telephone
–
If PoE is not supported: an additional network cable and an PoE Injector as
adapter between the network mains outlet and the Ethernet cable
Insert a plug of the network cable into the outgoing socket on the router/
1.
switch or into an existing network mains outlet.
Plug in the other plug of the network cable:
2.
i
COMfortel 1200 IP - Setup V03 09/2016
Commissioning
User name: root
Password: root
Password: - (no password)
DCHP enabled
IP address: 192.168.0.200
Network mask: 255.255.255.0
In a network that supports PoE: Plug in the other plug of the network
cable into the socket labelled
Commissioning
on the bottom of the telephone.
41