Connecting The Telephone To A Pc And Installing Usb Driver (Only Comfortel 2600) - Auerswald Comfortel 2600 Inbetriebnahmeanweisungen

Commissioning
Further steps
Assign the announcements to the various call types. You can assign the
announcements either via the menu on the display (in answer.machine >
functions > TAM announcem. > ...) or via the PC-software included in the
package (recommended; see
Connecting the Telephone to a PC and Installing USB Driver
(only COMfortel 2600)
If you install the USB driver, you will be able to configure the telephone from the
USB port on a PC.
Note: You can also configure the telephone using a PC that is connected
to the PBX over a PC port (see the instructions of the PBX).
Requirements
– The Auerswald Mega Disk included in the package
– A PC with the following features:
– The PC must be located near the telephone.
Important: The length of the USB cable used for connecting may be a max-
imum of 3 m (like the cable included in the package).
Note: The steps below describe how to configure the settings on the Win-
dows XP operating system. If you are using another operating system,
please refer to the documentation for your operating system.
1.
Switch the PC on.
2.
Insert the CD (Auerswald Mega Disk) into the CD ROM disk drive.
54
Intel Pentium 800 MHz or compatible processor
Windows XP (as of Service Pack 3), Windows 7 32-/64-Bit,
Windows 8 32-/64-Bit
Memory (RAM: 256 MB, recommended 512 MB;
for Windows 7/Windows 8: 1 GB, for 64-bit, 2 GB
USB interface: USB specification 1.1 or 2.0
CD-ROM drive
Mouse or compatible pointing device
SVGA graphics card with a resolution of 800 x 600;
recommended 1024 x 768 and 65536 colours (16 bit)
COMfortel 1600/2600 - Firmware Version 1.2A - COMfortel Set 3.4 - Setup V04 09/2013
Page 57).