Assembling The Telephone - Auerswald Comfortel 2600 Inbetriebnahmeanweisungen

Preparation
1.
Insert the headset connector into the jack labelled with
side of the telephone.
2.
Guide the cable to the outside using the corresponding cable channel.
Further Steps
COMfortel 2600 only: After commissioning, select the headset type that is
being used (in settings > headset > headset type).
In order to use the headset for calls, enable the headset operation at the
end of commissioning (in functions > headset).

Assembling the Telephone

Requirements
– Existing connections in the immediate vicinity of where the telephone is
placed:
Note: The telephone can be operated not only on an internal S
also on a U
nected. Also see the instructions of the PBX.
Warning: Liquid entering the casing can cause life-threatening electric
shocks and damage or destroy the telephone.
Attention: Mechanical stress and electro-magnetic fields can result in the
damage or destruction of the device or impairment of its functions.
48
ISDN socket outlet connected to the PBX
For the operation with COMfortel Xtension300 key extension modules:
230 V network mains outlet
port on the PBX. Only one telephone per U
P0
Only operate the telephone in closed, dry rooms.
Avoid mechanical loads (e.g. vibrations).
Avoid the proximity of devices which radiate electro-magnetic fields (for
example, radio sets, professional radio equipment, amateur radio
equipment, mobile phones, DECT systems, WLAN routers, etc.).
Do not expose the device to direct sunlight.
Protect the device from dirt, excessive dust, condensation, caustic liq-
uids, and steam.
Note the values for ambient temperature and humidity given in the tech-
nical data.
COMfortel 1600/2600 - Firmware Version 1.2A - COMfortel Set 3.4 - Setup V04 09/2013
on the lower
port but
0
port can be con-
P0