Commissioning; Commissioning The Telephone - Auerswald COMfortel 3500 Inbetriebnahmeanleitung

Commissioning

This section describes how to commission the telephone for the first time in a stepwise pro-
+
cedure. After a successful initial commissioning, you will be able to make internal calls. You
can customise your telephone using the computer configuration described at the end of this
section.

Commissioning the Telephone

Note: If you would like to integrate the telephone into an existing network,
please contact the system administrator responsible for this. Making
changes to an existing network may cause considerable malfunctions.
Requirements
– The patch cable delivered with the telephone
Note: If you require a longer or shorter patch cable, use one without snap
tab protection, because you may not be able to insert it far enough other-
wise.
– For the operation with Power over Ethernet: Bridge plug which is inserted
into the jack labelled with
– For the operation with power supply plug(s): Power supply plug(s) con-
nected to the telephone
– For the operation as system telephone: PBX with the following features:
Note: If required, make an update of the PBX (see the instructions for the
PBX).
– For the automated configuration from a provisioning server: provisioning file
which is stored on the provisioning server and is known on the DHCP server
Steps to Take
1.
Insert a plug of the patch cable into the jack labelled with
side of the telephone.
56
Commissioning
Switched on (connected to the 230 V mains supply)
COMpact 5010 VoIP, COMpact 5020 VoIP, COMmander Basic.2 and
COMmander Business: firmware version 4.2A or higher
COMpact 5000/R: 6.2A or higher
COMmander 6000/R/RX: firmware version 5.4A or higher
Internal telephone number entered in the configuration with the corre-
sponding password for the telephone
at the lower side of the telephone
COMfortel 3200/3500 - Firmware Version 1.8B - Setup Guide 04 02/14
on the lower