Initial Commissioning - Auerswald COMfortel D-series Betriebsanleitung

Initial Commissioning

Note: These Instructions describe how to perform initial commissioning
without provisioning.
1. Mount the device base. See Figure A 1.
2. Connect the device. See Figure A 2.
The device starts operating.
The company logo is displayed for 2 to 3 minutes.
The system displays a message that it is searching for provisioning files.
The telephone's IP address is shown on the display at the same time.
3. Write down the IP address.
4. Press the Cancel soft key.
You access the First setup menu.
Note: Then make these settings:
• Use the ▲▼ direction keys to navigate in lists.
• Use the keypad to enter numbers and characters.
• Press the OK key
Configuring language and location
1. Press the Country soft key.
2. Open Phone language.
3. Configure the language for the telephone (here: English).
The menu language changes.
4. Select Location.
5. Set the telephone's location.
6. Select Configuration manager language.
7. Configure the language for the configuration manager.
8. Press the back key
You return to the First setup menu.
9. The following alternatives are available for further configuration:
• Press the OK soft key to configure additional settings on the telephone.
See Configuring identity on the telephone.
• Press the WebUI soft key to enable Access > Web administration
(https). You can now conveniently configure additional settings in the
configuration manager. See Opening the Configuration Manager.
The First setup menu closes.
Configuring identity on the telephone
1. Open Menu > Settings > Identities.
You access a list of 6 unconfigured identities, marked with ---.
2. Open an unconfigured identity.
3. Then enter the data that is listed, depending on the operating mode.
Note: Hold down the digit keys to enter numbers.
to confirm your selection or entry.
.