Display Parameter - KEB COMBIVERT F4-F Lift Version 3.0 Kurzanleitung

Display Parameter

5. Display Parameter
X2 Input State
X2 Output State
GB-22
Terminal X2 (upper terminal)
With the X.2 input state it can be easily checked, whether the input
signals reached the inverter control. Every input (output) has a specific
value. If several inputs are set, the sum of the values is shown.
Value Table:
Display Valency
Combivis
ST 1
RST 2
F 4
R 8
I1 16
I2 32
I3 64 door drive setpoint setting
Example: Input control release (X2.1) and direction forward (X2.3) are
triggered with 24V .
Display value: 1+4 = 5
Terminal X2 (upper terminal)
With the X.2 output state it can be easily checked, whether the outputs
were set by the inverter control. Every digital output has a specific
value. If several outputs are set at the same time, the sum of the values
is shown.
Value table:
Display Valency
Combivis
O1 1
O2 2
control inverted
O3 4
control cabinet fan
Function
> G
control release
Reset
direction of travel forward
direction of travel reverse
control mode
door drive active
Function
> G
digital
output signal:
braking control
digital
output signal:
main contactor main contactor
relay relay ready-to-operate X2.20/X2.22
collective fault
Input
D + E terminal
X2.1
X2.2
X2.3
X2.4
X2.5
setpoint selection X2.6
binary-coded X2.7
Output
D + E terminal
X2.8
X2.9
control
overspeed