Commissioning Of A Permanent Magnet Machine With Gearbox - KEB COMBIVERT F4-F Lift Version 3.0 Kurzanleitung

Start-Up Instructions
4.4 Commissioning of a
Permanent Magnet
Machine with Gearbox
GB-20
The following procedure is recommended for the commissioning of
the KEB COMBIVERT F4-F lift version 3.0 with permanent magnet
machine and gearbox:
Adjust the parameters in ascending sequence, as this initiates partial
presettings of the unit. Start with the selection of the motor and the
resolution and adjustment of the lift data (LF-parameter). Save the
adjusted data by activating the „Enter key".
LF.00: Enter password (440)
LF.02: Enter setpoint setting/rotation setting
1 = Binary coded setpoint setting
2 = Input coded setpoint setting
3 = Analog setpoint setting 0...+10V
4 = Analog setpoint setting -10...+10V
LF.04: Adjust value „1"
LF.20: Enter system speed in m/s
LF.21: Enter diameter of the traction sheave, if necessary, remeasure
LF.22: Enter gear reduction, if necessary, count
LF.23: Enter rope suspension (1 for 1:1, 2 for 2:1 etc.)
LF.24: Enter additional load (lifting capacity, payload) of the cabine in kg
LF.31 to LF.33: Enter speed controller data (use pracmatical values
or inquire about adjustment at KEB)
LF.40: Enter correction speed in m/s
LF.41: Enter crawl speed in m/s
LF.42: Enter rated speed in m/s
LF.43: Enter inspection speed in m/s
dr.01: Enter rated motor speed in rpm
dr.02: Enter rated motor current in A
dr.03: Enter rated motor frequency in Hz
dr.09: Enter rated motor torque in Nm
dr.17: Enter EMK voltage constant in V/1000 rpm (if only the motor
voltage is known, EMK can be calculated according to following
formula: U
EMK
dr.41: Enter winding resistance in Ohm
dr.42: Enter winding inductivity in mH
EC.01: Enter encoder pulse number. (If a resolver is used, the
parameter must not be changed).
EC.04: Enter value „1" to execute a position alignment and give a
drive command. Cancel drive command, when value „5" is
displayed. In doing so make sure that the machine is unloaded,
i.e. the ropes may not rest upon the traction sheave.
If the position alignment is successful completed, value „7" is
displayed.
= U / n x 1000 rpm)
N N