Operation Of The Unit; Keyboard - KEB COMBIVERT F5 MULTI Betriebsanleitung

Operation of the Unit

3. Operation of the Unit
3.1

Keyboard

When switching on KEB COMBIVERT F5 the value of parameter CP.1 appears (see Drive mode to switch the
keyboard function).
GB The function key (FUNC) changes between the parameter
value and parameter number.
With UP (▲) and DOWN (▼) the value of the parameter
number is
parameters.
Principally during a change, parameter values are immediately accepted and stored non-volatile. However, with
some parameters it is not useful that the adjusted value is accepted immediately. In these cases (CP.28, CP.32,
CP.33, CP.34) the adjusted value is accepted and stored non-volatile by pressing ENTER.
If a malfunction occurs during operation, then the actual display is overwritten by the alarm message. The alarm
message in the display is reset by ENTER.
With ENTER only the error message in the display is reset. In the inverter status display (CP.3) the
error is still displayed. In order to reset the error itself, the cause must be removed or a power-on
reset must be made.
GB - 10
increased/decreased with
== Error ==>
changeable