Password Input; Operating Display - KEB COMBIVERT F5 MULTI Betriebsanleitung

Parameter description

3.2.1 Password Input

CP.00 Password Input
Ex works the frequency inverter is supplied without password protection, this means that all changeable parameters
can be adjusted. After parameterizing the unit can be barred against unauthorized access (Passwords: see last
but one page). The adjusted mode is stored.
GB

3.2.2 Operating Display

The parameters below serve for the controlling of the frequency inverter during operation.
CP.01 Encoder 1 speed
Co-domain
0...±4000 rpm
CP.02 Setpoint display
Co-domain
0...±4000 rpm
CP.03 Inverter status
The status display shows the actual working conditions of the inverter. Possible displays and their meanings are:
GB - 12
Barring the CP-Parameter
Enabling the CP-Parameter
Description
Display of actual motor speed ( incremental encoder 1). For control reasons the set speed
is displayed, even if the control release or direction of rotation are not switched. A counter-
clockwise rotating field (reverse) is represented by a negative sign. Precondition for the
correct display value is the in-phase connection of the motor and the correct setting of the
encoder line number (CP.20) as well as the direction of rotation (CP.21).
Description
Display of actually set value. For control reasons the set speed is displayed, even if the
control release or direction of rotation are not switched. If no direction of rotation is set,
the set speed for clockwise rotation (forward) is displayed.
„no Operation" control release not bridged; modulation switched off; output voltage = 0 V; drive
is not controlled.
„Low Speed" no direction of rotation preset; modulation switched off; output voltage = 0 V; drive
is not controlled.
"Forward Acceleration" drive accelerates with direction of rotation forward.
„Forward Deceleration" drive decelerates with direction of rotation forward.
ENTER
Password
UP
FUNC
ENTER
Password
UP
FUNC