Anhang
A.1 Normen und Vorschriften
A.1.4
Maschinensicherheit in Japan
Die Situation in Japan ist anders als in Europa und den USA. Vergleichbare gesetzliche
Anforderungen zur funktionalen Sicherheit wie in Europa existieren nicht. Ebenso spielt die
Produkthaftung keine solche Rolle wie in den USA.
Es gibt keine gesetzliche Anforderung zur Anwendung von Normen, aber eine
Verwaltungsempfehlung zur Anwendung von JIS (Japanese Industrial Standard): Japan
lehnt sich an das europäische Konzept an und hat grundlegende Normen als nationale
Standards übernommen (siehe Tabelle).
Tabelle A- 1 Japanische Standards
ISO/IEC-Nummer
ISO12100-1
ISO12100-2
ISO14121- 1 / EN1050
ISO13849-1
ISO13849-2
IEC 60204-1
IEC 61508-0 bis -7
IEC 62061
226
JIS-Nummer
JIS B 9700-1
JIS B 9700-2
JIS B 9702
JIS B 9705-1
JIS B 9705-1
JIS B 9960-1
JIS C 0508
Funktionshandbuch Safety Integrated, SINAMICS G120 unmd G120C
Funktionshandbuch, 01/2011, FW 4.4, A5E03052391A AB
Bemerkung
frühere Bezeichnung TR B 0008
frühere Bezeichnung TR B 0009
ohne Annex F bzw. Route Map des
europäischen Vorwortes
noch keine JIS Nummer vergeben