switch on the PBX. The configuration data stored on the USB memory stick will
automatically be saved to the PBX after switching on. The PBX restarts afterwards.
Requirements:
• PBX connected to earthing and casing closed
Connect the PBX to a freely accessible Schuko socket.
The Power and Status LEDs light up several seconds/minutes in
red and orange.
When the LEDs light up in green, the PBX is ready for operation.
Note: If the Power LED remains continuously lit in red, an error has occurred. Please
contact your dealer or the manufacturer directly.
Commissioning (COMpact 5200R/5500R)
Rack Mounting the PBX
Warning: Touching voltage-carrying conductors or telephone connections can
cause life-threatening electric shocks.
• Mount the PBX close of an earth wire (potential compensation bar of the house
installation or protective earth conductor). Connect the PBX's earth connection to the
earth wire with a connecting cable whose conductor diameter is at least 2.5 mm
Warning: Liquid entering the casing can cause life-threatening electric shocks or
damage or destroy the PBX.
• Only operate the PBX in closed, dry rooms.
Caution: Overheating can damage or destroy the system.
• Note the ambient temperature values indicated in the technical data.
• Make sure that heat produced by the device can be adequately vented into the
environment. Do not install the system in a cabinet without adequate air circulation.
• Never cover the air vents of the casing.
Important: Mechanical loads and electro-magnetic fields can impair PBX operation.
• Avoid mechanical loads (e. g. vibrations).
• Avoid the proximity of devices that generate electro-magnetic fields (e. g., radio sets,
professional radio equipment, amateur radio equipment, mobile phones, DECT systems,
WLAN routers, etc.).
• Protect the PBX from dirt, excessive dust, condensation, caustic liquids, and steam.
Requirements:
• 4 screws
• Connections close to the installation site:
COMpact 5200/5200R/5500R - Instructions V02 01/2018
Commissioning (COMpact 5200R/5500R)
²
.
45