Connections And Interfaces; Status Displays - Lenze 9300 Montageanleitung

EVS9330 ... EVS9332
(fold-out page on the right)
Position Description
Controller

Fixing bracket for standard mounting

EMC shield sheet with fixing screws for shielded control cables

Cover with fixing screws

Shield clamp and strain relief for the motor cable

Strain relief for the PE motor cable and the feed cable for the motor temperature monitoring with PTC thermistor

or thermal contact (NC contact)

Connections and interfaces

Position Description
L1, L2, L3, PE Mains connection
+UG, -UG DC supply
U, V, W, PE Motor connection
T1, T2 Connection of PTC thermistor or thermal contact (NC contact) of the motor
X1 AIF interface (automation interface)
Slot for communication module (e. g. XT EMZ9371BC keypad)
X3 Jumper for setting analog input signal at X6/1, X6/2
X4 Terminal strip for system bus (CAN) connection
X5 Terminal strips for connection of digital inputs and outputs
X6 Terminal strips for connection of analog inputs and outputs
X7 Sub-D connector (female) for connection of resolver and KTY temperature sensor of the motor
X8 Sub-D connector (male) for connection of incremental encoder with TTL level or SinCos encoder and KTY
temperature sensor of the motor
X9 Sub-D connector (male) for connection of digital frequency input signal
X10 Sub-D connector (female) for connection of digital frequency output signal
X11 Terminal strip for connection of K

Status displays

Position LED red
Off
On
Off
Blinking quickly
Blinking slowly
EDKVS9332X DE/EN/FR 2.0
relay output for "safe standstill" (for variants V004 and V024 only)
SR
LED green Operating status
On Controller enabled
On Mains is switched on and automatic start is inhibited
Blinking slowly Controller inhibited
Off Undervoltage or overvoltage
Off Active fault

99