Installation Check - Lenze 9300 Montageanleitung

5

Installation check

After completing the installation, the following must be checked:
Wiring for completeness, short-circuit, and earth fault
ƒ
In-phase connection of the mains cable
ƒ
In-phase connection of the motor cable (direction of rotation)
ƒ
If necessary, direction of rotation of the incremental encoder
ƒ

Note!
The installation check is followed by commissioning. Further information can
be obtained from the System Manual for the drive controller.
ƒ
ƒ
ƒ
EDKVS9332X DE/EN/FR 2.0
Read the System Manual carefully before you switch on the controller!
Carry out the commissioning steps in accordance with the System Manual!
If you use the "safe standstill" function, check the function of the circuit!

Installation check 5
191