Sharp VC-ME80GM Bedlenungsanleitung Seite 11

INSTALLING YOUR VCR
AUTO INSTALLATION
9. Press [.110./..."
l
to select SAT NO. Turn to the table at the end of this manual. Look for
the make of your satellite receiver and use the
NUMBER BUTTONS
to enter the first
code number listed. For example number 8 should be entered 0 0 8. Your satellite
should now change to preset channe112.
1D.lf
your satellite receiver has changed to preset channel 12/ press
SET
to
confirm the VCR will automatically install both satelli1e and 1errestrial channels. IThis
may take a few minutesl.
II.The VCR will attempt to copy the TV preset list INexTView, Smart Link, Easy Link and
Megalogic compatible Tv's only). During the copying process the display will show the
TV presets that are being copied. If the VCR is unable to copy the TV preset list the
terrestrial and satellite channels will be automatically installed. (Auto install may take a
few minutes.) On completion the MOVE menu will appear showing the preset channel
order. Press
MENU
to exit. If the clock is not automatically
set, the dock screen will
appear, refer to MANUALLY SErrlNG THE CLOCK To check the dock has been set
correctly, press DISPLAY until the time appears on the display. IF you wish to customise
the channel order refer to MANUALLY SORTING CHANNELS.
NOTES:
elfyoqrsatellite receiverhasn,~t,chang~d t() pres~t~hannel.12~nterthene~code
number on the list; Continue until the receiver showspresetchanneJ
12,
then .contiiju¢
from point 10. '
If your satellite receiver is.nqfliste~ althe endoHhi~ rnanuol or.lJtterenteririgOllthe
numbers .liste~ . . For y~~r: receiv~r" t~esatellite, r~ceiyefpres~tchanne<lhas still <n~t?hph9i;'q
to.12,. enter. 0 O,l,ondl.ook,
t~see
if
the satellite
rec~i~~r
has
changedtopr~set
channel 12. if it has, continue from point 10. If not, press
~
to select 0 0
2
and re-
check., Conti nue untilyour receive,r cHa~ges tl), presetl,~i~hen . . . cqntinue fr()nlPolnt
JO;
i<'lHhereis still . . no· response From.
yoursatellH~ receive~,tryadiusting ,it~.·positiQnt?
imProve the InFaRed
VfRto
satellHereceiyerrecepti~n;
' , . . ,. ....•• ,.'••. ,...•...•.••..•' , ....<>
• Auto-installation will slop when the satellile receiver reaches presel channel 99, or when
all the 84 VCR presel channels have been used .
• The VCR will place all found terrestrial channels slarting at preset 1, then all salellite
channels From the first (Jvailable presett;hannel after the terrestrial cha,nne1s. '
..j'
All the programmes should now be correctly tuned in and the clock set.
n
IF you
replace
your satellite receiver, you will need to Follow the
complete
outo-
U installation procedure to tune your VCR to the satellite receiver. This is because your
new satellite receiver will not over-write the previous satellite channels in your VCR.
IFiy~u.·. ~6nneda. sat~llite rece-iv~rtb
the
VCRior
the firsi',
fjfue,
SATELLITE RECEIVER
I
CABLE BOX INSTALLATION.
GB-9