Timer Recording - Sharp VC-ME80GM Bedlenungsanleitung

BASIC OPERATION
DIRECT TV RECORDING
THIS FEATURE CAN ONLY BE USED WITH NexTView, Smart Link, Easy Link
and Megalagic COMPATIBLE TV'S.
By pressing the
DIRECT TV REC
bunon on the remote control, the VCR will record the signal
currently being displayed on the TV regardless of the signal source.
This feature can be started when the VCR is in STANDBY or OPERATE mode, but NOT low
Power mode.
• If
E' J
appears on the VCR display, press
TIMER ON/OFF
before starting.
• Ensure a video tape is inserted in the VCR and the Hi·Fi Ree level Control is in its central
position ..
I.To start the recording, press
DIRECT TV REC.
2.To pause during recording, press
PAUSE
III).
3.
To continue recording, press
REC
Ie).
4.
To stop recording, press
STOP
1-).
NOTl'S;
, A
~lIywireciscart
must be used for
bIRECTJYi~!"G~lRpqperqtlo~.
lIlfDIR!"GITVREGqRDcoulci nol start, Ihe TV1lhoOlciinclicWelh¢feasQnWhY,
(Refer to ib e TV operation manuall
TIMER RECORDING
It
is
possible to program the VCR using three different methods :-
I.NexTView
2.Showview
3.Manually (DELAYED RECORDING)
HOW TO USE NexTView TO MAKE A RECORDING
• If
E' J
appears on the VCR display, press
TIMER ON/OFF
before starting.
• Check that the clock is displaying the correct time.
Some broadcasts transmit an Electronic Program Guide (EPGJ in which case, using the TV
controls, the program you wish to record can be selected and used to program the VCR
automatically. This feature is compatible with NexNiew
N's.
Refer to your
N
operation
manual for further information. After transfer of the timer information to the VCR, the timer
menu will be displayed for approximately 5 seconds, afier which press
TIMER ON/OFF
once to place the VCR in STANDBY mode.
E' J
will be shown on the display.
GB·16