Sharp VC-ME80GM Bedlenungsanleitung Seite 41

ADVANCED OPERATION
DECODER SWITCHING OPERATION
If
you connect a separate
decoder to the VCR connected to L2 as previously
shown,
you
will
need to set the decoder function to ON in order to record the descrambled signal and/or
watch it on your TV. Now, when the VCR receives a scrambled signal it is output via LINE 2
terminal to the decoder. The decoder then outputs the descrambled signal back to LINE 2
terminal and the signal can be recorded. The VCR outputs the descrambled signal to your TV
through the lINEl terminal and you can watch the descrambled picture.
When making recordings using a separate decoder connected as shown remember to leave
the decoder function ON.
If
you connect a
decoder unit to the VCR, the decoder unit provides a sWitching signal which
will automatically allow your TV to display the descrambled signal routed through the VCR.
To use this feature make sure that the VCR is connected to both TV and decoder unit
by
SCART leads. Then:
• Press STANDBY to place the VCR in Stand·by mode, OR
• Press [TV/VCRI an the remote control ia place the VCR in 'VCR made'. 'VCR' will
appear on the display.
If you switch the decoder function ON when connected- to a decoder unit as shown you
will
NOT be able to watch the descrambled picture in TV made or in VCR made.
GB·39