Basic Operation - Sharp VC-ME80GM Bedlenungsanleitung

BASIC OPERATION
IMPORTANT NOTES ON YOUR VCR AND VIDEO TAPES
VIDEOTAPES
• If
you use
only good quality video tapes, generally
it
will not be necessary
to
clean the
video heads.
• IF poor quality tapes are used, or if a tape is loaded after changing VCR location, oxide
from the tape may "dog" the video heads. This will cause the playback picture to be
" snowy
l',
or even disappear.
• To remove minor contamination run a video tape in visual search mode. If this fails, you
will need to have the heads cleaned
by
a SHARP Service Facility. Please note,
if
cleaning
is necessary it is nof covered
by
te ljIorantee.
• Use video tapes which carry the
\fI.IS
mark.
• This VCR does not playback or record S-VHS format video tapes.
HOW TO PLAYBACK A VIDEO TAPE
it
BEFORE YOU PLAYBACK A VIDEO TAP.
Condensation forms in the VCR when
it
is moved out of or into a warm place. IF
you try to playback or record, the video lope and VCR may be damaged. Turn the
VCR on and wait For about two hours until the VCR reaches room temperature
before operating.
-~~
C\
PLAYBACK
SD'
~
-,_.
. " , .
~ ~
1.
Switch on your
TV
and select the videa
-
_ 0
11
channel.
2.
Open the control panel and carefully
push a pre-recorded video tape into the
tape compartment. This will switch the
VCR on.
• If the record-protection tab has been
removed, the VCR will start playback as
soon as the video tape has been loaded.
3.To start playback, press
PLAY
1X2
I
~
).
Record-protection tab
GB-10