Autoinstallation - Sharp VC-ME80GM Bedlenungsanleitung

S.
INSTALLING YOUR VCR
AUTO INSTALLATION
VCR RESET
I. Press STOP to switch on the VCR.
2. Press and hold MENU and CHANNEL '"
bunons together on the front of the VCR for
10 seconds.
3. The AUTO INSTALLATiON screen should
now be showing on your TV. Press SET to
confirm.
4 •• Press [ .../",
1
to select your language
and press SET.
• Press [ .../", ) to select the country of
use and press SET.
• Ensure your AERIAl/SCART cable is
connected to your VCR and then press
SET
to confirm.
S. SAT CONTROL will be highlighted.
• IFyou
do
have a satellite receiver connected
to the
VCR
continue from point
6.
• IF you
do not
have a satellite receiver
connected to the VCR leave SAT
CONTROL set to OFF and press SET.
The VCR will anempt to copy the TV preset list (NexTView, Smart link, Easy link and
Megalogic compatible TV's only). During the copying process the display will show the TV
presets that are being copied. If the VCR is unable to copy the TV preset list the terrestrial
channels
will
be automatically installed. (Auto install may fake a few minutes.j On
completion the MOVE menu will appear showing the preset channel order. Press
MENU
to
exit. If the
~Iock
is' nof automatically set, the clock screen will
appear, refer to MANUALLY
SETTING THE CLOCK. To check the clock has been set correctly, press DISPLAY untH the
time appears.on the display. If you wish to customise the channel order refer to MANUALLY
SORTING CHANNELS.
-I
All the programmes should now be correctly tuned in and the clock set.
Points
6-11.
(Satellite/Cable
Box
Control only)
6.Select Channell on your satellite receiver.
7. Press [ ""/~ ) to set SAT CONTROL to ON.
B. Press [ .../"') to select INPUT. 12 will be highlighted. If the VCR is not connected to
the satellite receiver as shown previously.
(i)
Your satellite receiver should be connected to the Antenna (RF in on the back of the
VCRI select RF IN using [ .."
I~
).
You will need to tune the VCR into the Satellite
receiv~r.
(ii) Press [
,,,,) to select CHANNEl.
(iii)Press [ ]. The current channel will be displayed as a background to the on-screen
display. If this is not a satellite channel press [ ..... ]again. Continue until you see a
satellite channel.
GB-B