Sharp VC-ME80GM Bedlenungsanleitung Seite 43

CUSTOMISED INSTALlATION
MANUALLY TUNING A CHANNEL
Normally
it
will not be necessary to tune in a broadcast channel manually except in unusual
circumstances such as poor signal.
Ensure the video channel is selected on the TV
I.Press
MENU.
Press [ ...., ..... ] to select
SET UP. Press SET to confirm.
2.CHANNEL PRESET will be highlighted.
Press SET to confirm.
3.MANUAL TUNING will be highlighted.
Press SET to confirm.
4.
PRESET will be highlighled. Press [
~/~]
to choose the required VCR preset channel.
5.lf you have SATELLITE CONTROL set to
ON
continue from point
6. Otherwise
continue from point
7.
6. Press [ ...., ..... ] to select SOLIRCE. The
choose the required source:
• If you wish to tune a satellite or cable
channel press to [
~ I~
]
select SAT.
Then press [ ...., ..... ] to select
CHANNEL. Enter preset satellite channel
using
NUMBER BUTTONS
or [
~ I~
]
to step through each preset satellite channel until the channel you wish is displayed.
Continue from point 10•
• If
you wish to tune a terrestrial channel press to [
~/~
] select CH.
Continue from point 7.
7.Press [
' ..... ]10 select channel.
8. Press [ ,.... ] to start tuning in either direction. Tuning will stop when a channel is
received. IF it is not the desired channel, press [ ..... , .. ] to continue tuning.
9. Press [ .... , ..... ] to selecl FINE TUNING. Press and hold [
~/~
] until the sharpest colour
picture is obtained.
IMPORTANT NOTE:
10. Press [ ...., ..... ] to select the DECODER. This is preset to OFF. If you connect a
satellite receiver into VCR
l2,
as shown previously, leave decoder OFF.
If
you
connect a decoder, as shown previously, you must use [ ..... , ... ] to turn the decoder
function ON. Refer to
DECODER SWITCHING OPERATION.
GB·41