Sharp VC-ME80GM Bedlenungsanleitung Seite 53

TROUBLESHOOTING
TROUBLESHOOTING
PROBLEM
ANSWER
Display· is not working. •
Make sure the VCR is nol in LOW POWER mode.
•
Make sure the power cord is plugged in.
• N\ake sure the wall socket has power (plug another applicmce in).
VCR will not operate. 0 appears
• Press the TIMER ON/OFF button to disengage timer.
in VCR disp
lay.
VCR will
nol
respond to any
•
Check CHILD LOCK is not engaged.
commands.
•
Safety device operating: unplug VCR for 2 hOUJs.
Tape cennot be loaded.
•
Make sure there is no other tape in the VCR.
•
Make sure you are loacling the tope correctly.
VCR
cannot
be operated
by
remote
•
Remote control is too for away from the moin unit.
control.
•
Point the remote control at the VCR.
•
Batteries are flat - replace both.
•
Balleries have not been inserted correctly.
• VCR is positioned in strong light.
• Check VCR CODE is set correctly.
No picture appears.
•
Make sure TV is set to the video channel.
•
Check all connecting cables.
.
Rewind is not possible. • Make sure tape is not at the start.
Picture does not change even •
Make sure VCR is not in timer or menu moqe.
though CHANNEL A/"'" buHons
are pressed.
Desired channel position cannot be • The channel position has been set to be skipped.
selected.
Cancel the skip mode for that channel.
No colour or poor TV picture on • Make sure all the cables are connected
proper~.
normal viewing. •
Make sure VCR power cord is properly plugge in.
Playback picltJre is snowy. •
Adjust the tracking using CHANNEL
At'"
buHons.
•
T!y another tape.
•
The video heads may have been contaminated· refer to a SHARP
Service Facility.
Tape is automatically ejected when
•
The record-protection tab has been removed.
pressing RECORD
I •
J
or TIMER
ON/OFF buHons.
Playback/ recording does not
•
Ensure VCR is connected to a stereo TV and SCART lead.
playback in stereo.
•
Programme may not carry stereo.
SHOWVIEW does not record
•
Broadcast does not carry VPS/PDC signal which alters recording
desired programme.
time. .
•
Check VPS/PDC mode is switched to ON.
•
Ensure date and lime are correctly set on the VCR.
Satellite receiver does not respond
•
Adjust the position or angle of the satellite receiver.
to VCR commands.
Desired satellite channel cannot be • R8'"install all channels ensuring that the satellite receiver is not in
selected by the VCR.
a~
special channel setting mode and thot the desired channel is
be ow channel 99 on your satellite receiver.
HiFi Record Low audio leveL
•
Ensure HiFi Rec Level Control is set to its central position before
recording.
GB-51