Child Lock - Sharp VC-ME80GM Bedlenungsanleitung

SPECIAL FEATURES ON YOUR VCR
LOW POWER FEATURE
To meet new power regulations your VCR can be placed in lOW POWER mode. In lOW
POWER mode the VCR power consumption is reduced to below 1
Waff.
LOW POWER MODE
I.Press
STANDBY
(<91
to place the VCR in STANDBY mode.
2. Press
STANDBY
(<91
again to place the VCR in LOW POWER mode. The VCR digital
display will appear blank.
The VCR power consumption will
now
be below
I Watt.
DISENGAGING LOW POWER MODE
Either
Press
STANDBY
(<9)
to return the VCR to STANDBY mode.
Or
Press
STOP (.
I
to use the VCR.
NOTES:
' •.With.,.pqqr,SIijnal conditions
CJnin:reas~jn. n;ise·.m?Y:Pi~R:s~rye,d'~9th~.spr~e?intOW
•
~:E:n';;,~~~
STANDBY, noise may be observed. ':, .
• If a signql is input fram an AV source, the VCR may not go into true LOW POWER mode.
• When disengaging LOW POWER' mode from the VCR press the STANDBY buffon.'·
CHILD LOCK
You can lock your VCR with this feature. It will work even when the VCR is in standby,
preventing children from operating the VCR.
TO ENGAGE CHILD LOCK
Press and hold
@liiJ
on the remote control for about 2 seconds.
@;;,
flashes and then
@;;,
remains lit on the VCR dispby conRnming that CHILD LOCK
has been adivated.
Regardless of what other operating buttons are touched, the VCR will continue to operate in
its present mode. If CHILD LOCK is activated during playback, once the tape reaches its
end, the VCR will automatically rewind the fape, eiect it, and turn the power off.
TO DISENGAGE CHILD LOCK
Press and hold ©iii! for about 2 seconds.
©iii
starts flashing and then disappears. CHILD LOCK is disengaged.
G~40